I wonder if there is an issue with the module 2 precharge unit. The 6 pin descriptions are different than the newer 10 pin and possibly (probably) miswired in some way. In particular mi...
I wonder if there is an issue with the module 2 precharge unit. The 6 pin descriptions are different than the newer 10 pin and possibly (probably) miswired in some way. In particular mi...
Hi Ben, When I go into tasks to relay 1 set to highest cell - negative to off, and put a lower voltage in than present, it does trip the charge relay and leave the load relay connected. Good! &nbs...
@BenOkay, wired per this diagram and settings as per your task-relay1 (charge relay), when I test for LVC the charge relay trips open instead of what I thought should be the load relay. Not s...
@Ben Page 7 of the manual you linked above. For the other relay, is that the opto in tasks?
@Ben Thanks for getting back to me. I do have 2.9.2-2 loaded. Tried to edit my earlier post but couldn't get it. I'll try your settings and look at that manual for a start. ...
Best of the New Year to All, I have a 3p4s 12v setup on my boat that I thought I had working correctly but something is not right. No fancy Blue stuff here, all old but working just the same...
