Posts made by Franz

• BMS does not switch to float

  Hi everyone,I've been monitoring this behavior and noticed the following:The BMS only switches to float mode once the set float voltage is reached or drops below that threshold. With a Victron syst...

  posted in REC Q Series BMS

  F

  Franz
  4/22/25, 12:29 PM
• BMS does not switch to float

  Hi Ben, My setup includes just one charge controller and three MultiPlus-II units, all from Victron. The system is configured in ESS mode with surplus feed-in enabled. I’m guessing that&rsqu...

  posted in REC Q Series BMS

  F

  Franz
  4/10/25, 6:43 AM
• BMS does not switch to float

  Hi everyone, I'm encountering an issue with my 2Q BMS: when the configured end-of-charge voltage is reached, the BMS doesn't lower the voltage accordingly. As a result, my Victron system doesn't s...

  posted in REC Q Series BMS

  F

  Franz
  4/9/25, 12:23 PM