Master Slave Config PC BMS Control Software

• J

  Jack

  9/29/24, 2:21 PM

  I'm trying to establish a connection with the slave using the software. Unfortunately, without success. Can anyone help. I can't reach the slave, address 1 and 2 are not recognized. What's wrong here?

  Master connection 16 with 0 works without problems.

  

  
  
  
  
  
  
  
  

  0 likes 0 likes Liked Like

  ---

  9
  Posts

  181
  Views

  Reply

  ---

• R

  Rick OGM Support Staff

  9/30/24, 12:19 PM

  are the green LEDs on the slave blinking about once a second?

  Are you using addresses 16 and 1 to try and connect?

  0 likes 0 likes Liked Like

  ---

• J

  Jack

  9/30/24, 4:55 PM

  Yes, the green light is flashing on the slave. I've tried more settings. It doesn't work.

  0 likes 0 likes Liked Like

  ---

• J

  Jack

  9/30/24, 4:58 PM

  

  0 likes 0 likes Liked Like

  ---

• J

  Jack

  9/30/24, 4:59 PM

  

  0 likes 0 likes Liked Like

  ---

• J

  Jack

  9/30/24, 5:01 PM

  

  0 likes 0 likes Liked Like

  ---

• J

  Jack

  9/30/24, 5:02 PM

  

  0 likes 0 likes Liked Like

  ---

• R

  Rick OGM Support Staff

  9/30/24, 6:05 PM

  for most operations you connect to the Master to retreive all slave parameters, not to the slave.  Only things like slave firmware updates .  I see that your pack voltage is 104 volts so it seems you have a high voltage series configuration.  

  0 likes 0 likes Liked Like

  ---

• J

  Jack

  10/1/24, 12:37 AM

  Yes, it is a high-voltage system. Nevertheless, it should be possible to reach the two slaves. So far without success?

  0 likes 0 likes Liked Like

  ---