Hey, I want to have the feature in wire activate half power mode when voltage is applied to the feature in wire. The only option I can see in the app is "select half power mode (inverted ...
Hey, I want to have the feature in wire activate half power mode when voltage is applied to the feature in wire. The only option I can see in the app is "select half power mode (inverted ...
Any insight on this old board? I have configured it on my bench with the barebones wires attached as per ricks suggestion. Ignition feed gets power the bulb turns on at max brightness.&nb...
Field winding is fine. Showing 6.9Ohms now. It was a problem with the multimeter. The cable numbers you say dont seem to match what I have on my plug? I have the 1.0 Board 2018. Perhaps the pl...
@Rick Thanks.Will try this. I was testing this morning and it seems I am getting 19 Ohms between the two field wires which seems fairly high.
Would this issue happen if the field is wrong?
@Ben Currently one side of the field goes to B+ alternator positive. The other goes to the wakespeed pin 7 "wakespeed field" blue wire.
@Rick When the regulator field wire is removed it doesnt power the alternator. When the regulator ign feed it off it doesnt have the issue. There is no regulator on the alternator ...
I have just installed my WS500 and it seems the field is always at 100%?Even when the regulator is in the "off state" As soon as the ignition triggers the regulator to be on I can hear the alterna...
Hey, Just installing my WS500. (replaced a Mastervolt Alpha Pro III with it). It seems far superior with the canbus support. Even with the janky usb port / app. 😅I have installed a s...
Hello, Can anyone tell me which resistor and pinout is needed to create my own terminator for the WS500 Thanks.
