WS500 Feature In Wire (non Reversed)

• R

  Ryan

  1/26/24, 1:24 PM

  Hey, 
  
  I want to have the feature in wire activate half power mode when voltage is applied to the feature in wire. 
  
  The only option I can see in the app is "select half power mode (inverted output)"
  
  I dont want inverted output. 
  
  Any ideas? 

  0 likes 0 likes Liked Like

  ---

  2
  Posts

  76
  Views

  Reply

  ---

• P

  Peter

  1/29/24, 11:40 AM

  I can not think of any way to do this in the settings. The only way would be a normally closed relay to invert the output but that results in current draw which may not be possible depending on your source. Do not know if you could get a solid state relay.

  0 likes 0 likes Liked Like

  ---