Configuring REC Active BMS using only the WIFI Module

• R

  Rich

  4/15/22, 8:34 PM
  I\'ve purchased the WIFI module thinking I would be able to fully configure my system using that interface.  I find it only allows me to edit a limited number of parameters.  I\'m not able to configure the relay parameters such as RE1LO AND RE1HI.  I also can\'t modify the CANbus baud rate.  Am I missing something?
  0 likes 0 likes Liked Like

  ---

  3
  Posts

  1.1k
  Views

  Reply

  ---

• R

  Richard OGM Support Staff

  4/16/22, 6:29 AM
  All of your secondary variables can be set and viewed using the \"Manual Input\" function on the \"Firmware\" page of the WiFi Module. You will need to log in first before this option appears near the bottom of the page and set your device address.  Usually 1 for Q/SI series and 2 for Active BMS.  See page snip for example
  1 likes 0 likes Liked Like

  ---

• R

  Rich

  4/17/22, 3:43 PM
  I knew I was missing something.  Thanks so much for the prompt response - especially on a holiday weekend!  
  0 likes 0 likes Liked Like

  ---