Thanks @al-thomason The 2.5.0 firmware update using your uploaded DFU file was successful on both of my regulators. I used the windows dos command line setup that I previously used for the 2....
Thanks @al-thomason The 2.5.0 firmware update using your uploaded DFU file was successful on both of my regulators. I used the windows dos command line setup that I previously used for the 2....
Where can I download the latest W500 firmware? Wakespeed instructions say to look at the \"technical\" page on their website. Did Wakespeed remove access? Also the STM drivers link above doe...
Regarding the 7amp max draw when switching. That current craw comes from the 15Amp fused power supply (red wire), *NOT* the NO (brown) or NC (orange) switch circuit. So I don\'t think the BMS in...
An even better solution is to use Blue Sea Systems 7713 or 7718 which operates like a Normally-Open RELAY, instead of the 7700 which needs a special circuitry to connect. It appears the 7713/771...
I found a solution for adding pins. Since I am not using all the OPTO wires in the harness, remove two of those and move them to the RELAY NC pins on the AMPSEAL connector. Detailed Instruction...
I am running into this same issue. Was planning to connect the Relay NC wire to drive the bistable relay per the cruiserforum schematic . I am surprised the Relays NC wire was not populated in th...
Can I accurately conclude that this integration requires the REC BMS to be installed to glue these other two pieces together. So Victron CCGX + W500 alone do NOT integrate, but Victon CCGX, W500...
The pinouts are different between the W500 Can interface and Victron CAN. With that corrected, the first W500 shows up on the CCGX CAN device list.... Not seeing the second W500.
I am in the process of installing a new battery bank, external regs (2x W500) and REC BMS. In my \'taking small steps\' approach I installed with W500s first and want to get them working with my e...
