Rick, Thanks, but I would be able to use both main relays? and set both relay parameters for open at low cell voltage? Then I would only need one Opto relay for the third Tyco with use of an relay ...
Rick, Thanks, but I would be able to use both main relays? and set both relay parameters for open at low cell voltage? Then I would only need one Opto relay for the third Tyco with use of an relay ...
Hi, The Tyco relays 9-36V use 0,13A Holding current. I want to set differnt UV settings on all three relays if possible. I also have one Pre-charge unit.
Hi, Can I have three Tyco power relays (12V) connected to three differnt discharge busbars that shall open on Under voltage? Which relays in the BMS should I then use?
Hi, Is there a way to have both a Wifi module and a REC LCD screen connected to a Mater BMS system at the same time?
Hi, Have a Master BMS were the external fuse was blowed. Now the BMS will not start up. Is there any fuse inside the unit? Power supply is 48 V in to BMS.
