I see. Do I reach out to Tine directly over the forums or email?
I see. Do I reach out to Tine directly over the forums or email?
That makes sense. However I have the Q BMS. My understanding is there is some firmware version that lets me control an external relay and have it turn off when nearing low voltage, before the main ...
I completed the update using the HW1.2 file and it worked. I can\'t tell that anything is different, but the WiFi module still works and shows the new firmware version. The LCD still is flaky to...
Thanks Rick, that sounds good to me. I super appreciate how you handle things. My system is currently only on when I am working on it, so I can definitely do without the module for a few days. I...
Thank you for the reply. I am confused then, how come I have a module that says HW 1.0? I purchased it through Offgrid Software Solutions, nothing was mentioned about it being a prototype. If it...
Hm, that is weird. I could go ahead with the update but I wouldn\'t want to brick anything or make my life harder. Would rather hear back that I should upgrade even though it says HW:1.0 at this po...
Hello My Wifi module is showing HW:1.0 SW:1.5.1 at the bottom of the firmware upgrade screen. Does that mean I have a beta? I do experience issues with the LCD screen, it is unreliable and so...
Nice, thank you. I will contact them when closer to doing my install.
Hi! Wondering if there have been any updates on this. Thank you!
I unfortunately took a break from the project and haven\'t gotten to figuring that part out yet.
Hello! I have the BMS connected to Cerbo GX, which is also connected to a Multiplus 3000. I have enabled DVCC/SVS/STS like the BMS manual suggests and I am running an unexpected problem: when I di...
Okay, great. So sounds like the SI has no advantages whatsoever for my setup. Thank you!
Does the Q series unit you have also have the \"\"soft\" disable your inverter and charger before initiating a hard relay trip. In addition it has some cool PV logarithms.\" that you mentioned abo...
Unfortunately that won\'t be possible for me since my van already comes with two alternators from the factory, and they are both 12v and interlinked together (it\'s a 2021 Ford Transit). So I am st...
Thank you. Unfortunately my battery pack is 24v and my alternators are 12v (the van comes with two alternators and I cannot replace them or add a third one) so I am not sure the WS500 would be poss...
To follow up on this, for a mobile (Van/RV) installation that has a 16 cell LiFePo4 pack, Victron Multiplus 3000, SmartSolar MPPT 100/30 and CerboGX, would you recommend the Q or the SI? Thank ...
