I dont think you want to set it back to half power mode on an OV disconnect. My solution in the past was to just add the interposing relay in parallel with your your OV coil and cut your field as ...
I dont think you want to set it back to half power mode on an OV disconnect. My solution in the past was to just add the interposing relay in parallel with your your OV coil and cut your field as ...
its on the todo list but it could be a while
Trond, I am going to forward this one to Al at Wakespeed for followup. @al-thomason
Thanks Ben, you beat me by a few minutes :) Jan, to add to Bens reply, this alternator contains additional items within its housing and the back mounted regulator can not just be swapped out as ...
Jan, I looked over the wiring diagram and will need to dig a bit deeper before I can get back to you with a reply.
Not sure what your CE CAN adapter is and a quick google search didn\'t find it, but your CANBus network is basically a 2 wire daisychain, wiht 2 wires for power and another for the shield. The ide...
Neil, The low limit for warmup delay is hard coded into the regulator, so even trying to set it manually with puTTY will not help. I am not sure that using the lamp will help you, b...
You should be able to connect your Multi to a VE.bus Connect your REC BMS to the VE.CANBus port 1 Connect your WS500s in series to VE.CANBus port 2, with a terminator plugged into your last W...
You can find the complete list when you build your BMS kit here. After adding accessories just specify what Inverter driver you want. https://www.offgridsoftwaresolutions.com/product/rec-si-bms/
Nothing is jumping out at me here Patrick. My reference to battery pack cable lengths only applies if you have multiple groups of cells, like in a 2P4S 2P configuration. Because you only have a s...