Following up on this in case someone else has the same question. I was able to get this to work by getting an ethernet cable, cutting off the end and attaching a nmea2000 field connector. Wir...
Following up on this in case someone else has the same question. I was able to get this to work by getting an ethernet cable, cutting off the end and attaching a nmea2000 field connector. Wir...
Hi there, I have the above 3 units wired REC -> Cerbo -> WS500 with a terminator at each end. To connect to my NMEA2000 network, would I be right in thinking I would take out the termin...
Quote from Trond Arvid Røsvik on August 7, 2022, 2:58 am Quote from Matthew Parsons on August 6, 2022, 11:47 pm I have a question - my ws500 is hooked up to my cerbo, I can see it in the device...
I have a question - my ws500 is hooked up to my cerbo, I can see it in the device list. Its controlled by the REC BMS using DVCC and seems to work great, the only issue is that I can\'t seem to ...
Thanks Rick, somehow missed the mention of the configuration mode. I have the crossover cable and the terminators and will install the new shunt to just measure the alt current!
Hi there, Installing my WS500 and a few questions: firstly, while configuring the unit while it\'s not plugged into anything but the USB cable, it works fine for around 30 secs to...
Hi guys Just wondering if I can confirm my value as the formula is a beast! For a 500A/75mA shunt, it would be 1.30208e-2 - is that correct?
I connected my BMS cell voltage wires according to the labels on the wires, but when I check the voltages on the plug, the negative is on the left top of the plug, instead of the right top in the m...