I have just recieved the new firmware from rec bms.
I have just recieved the new firmware from rec bms.
Hi Ben It looks very nice. Am I understanding it right, that the new CFVC is a user configurable parameter? Is this firmware released?
I now very well that the hysterese factor is not programable, but I made it that way to see how diferent factors inflict on the calculation. The \" Low end of charge\" is the CVL calculation \"...
Hi I have made a spred sheet based on the information in Ben\'s spred sheet. It\'s a dynamic spred sheet where end of charge voltage, end of charge voltage hysterese and the factor ...
Thanks, I would realy like to see your thoughts about the rec cvl calculation. Maybe you can pack it in a zip file and get under the 10k limit? I\'m not sure a factor at 1 is the right one, b...
Yes I can but then I have a to high \"float voltage\", so it does not solve the problem. Problem still persist. The factor is still a big problem.
Hi CVL is calculated 4*(CHAR-(CHIS*0.2)) according to the ABMS manual, but after some calculating the 0.2 factor is more like 0.5. The factor is a problem because it\'s to low. If you...