Posts made by Jim

• Can the Wakespeed be changed to handle a 5v intiate signal?

  Yep, those are possibilities, but as said I don't want to risk the current avaialability risk of using a data line to actually run anything.  There are wires shown in the diagrams off the igni...

  posted in WS500 User Installation and Programming Questions

  J

  Jim
  12/14/23, 8:37 AM
• Can the Wakespeed be changed to handle a 5v intiate signal?

  I chased this half the day today.  Got all the wiring done and in place, etc, Wakespeed programmed to my specs. Turn the key, NADA.  Not even a blink out of the Wakespeed. Checked the p...

  posted in WS500 User Installation and Programming Questions

  J

  Jim
  12/13/23, 8:29 PM
• Stator signal from DC Power XP280/Nations alternator

  I think the definitions are kind of sketchy sometimes, as they are with a lot of things.  My understanding is that they add phases in clusters of three with the clusters covering 360* so you g...

  posted in WS500 Tips, Tricks and support

  J

  Jim
  12/10/23, 7:52 AM
• Stator signal from DC Power XP280/Nations alternator

  That is another vote for the place that I also would normally chosen to get a good pulse signal,  between stator coil output and diode, but I found quite a few people stating to connect at the...

  posted in WS500 Tips, Tricks and support

  J

  Jim
  12/9/23, 7:29 PM
• Stator signal from DC Power XP280/Nations alternator

  I have been spinning my wheels for a couple of weeks trying to get and answer that is correct from Nations and DC Power Engineerng about the proper place to get a stator tach signal for the Wakespe...

  posted in WS500 Tips, Tricks and support

  J

  Jim
  12/8/23, 4:53 PM