My Abms has been working flawlessly but I got a new router and needed to reset the WiFi so I pressed the reset button on the rec WiFi for 20 seconds and now I can't see the abms.
The ABMS green led flashes 3 times then off then 3 timed then off some times it does 2 flashes.
I can't see the ABMS on the WiFi or on the victron cerbo through CAN.
Can anyone help I don't see green led code in the manual only red?
When you Factory reset the wifi module you lost the comms settings. The Active BMS address is 2. Here is a link to some tutorials that should help. It gets set on the "Firmware" page
Don't forget to power the wifi module down and wait 10 seconds before repowering as part of the Factory reset process.
@Rick yep that fixed seeing it in the WiFi module (I clearly forgot about setting that when I originally installed it 😊😃
Still can't see it on the CAN network though 😢
ok, good. For the CAN network, its likely a baudrate setup issue. I am going to send you a link to our new REC-Active Quick Start manual via email that steps you through it.
@Rick a couple of reboots and CAN details are all back working on the Cerbo screen, something obviously got out of whack!
appreciate your help
