I have read all of the available and sometimes conflicting documentation re how to set up, and configure the WS500 <--> Cerbo GX <--> REC-BMS set up.
It is like I am panning for gold... searching for all of the nuggets of correct advice.
Does such a guide exist? Or perhaps a Youtube video?
Same here. Good luck brother 😅
I would pay $$ for such a guide. Especially if there was someone that was keeping it up to date. I know that this forum is a great source of info, but the "forum" format makes it hard to pull out just the relevant details. The other option would be to create a "wiki" on this site that could be edited by those with relevant experience and then peer reviewed for accurancy and relevance. Quite frankly I've seen a lot of well meaning posts that I know to be wrong, either because someone did not understand the question or did not have enough knowledge or experience and should not be posting.
Did anyone get anywhere with this?
Latest I've seen is REC ABMS to Cerbo BMS-Can port. WS500 to Cerbo Ve.Can port.
I'm running an older Cerbo GX (not MK2) on 3.5.0 with a WS500PRO on 2.6.0. Have REC ABMS, cells, contactors, etc but haven't assembled.
Any new info would be appreciated!
