Hey,
I want to have the feature in wire activate half power mode when voltage is applied to the feature in wire.
The only option I can see in the app is "select half power mode (inverted output)"
I dont want inverted output.
Any ideas?
Hey,
I want to have the feature in wire activate half power mode when voltage is applied to the feature in wire.
The only option I can see in the app is "select half power mode (inverted output)"
I dont want inverted output.
Any ideas?
I can not think of any way to do this in the settings. The only way would be a normally closed relay to invert the output but that results in current draw which may not be possible depending on your source. Do not know if you could get a solid state relay.
